BUSBAR MACHINE

Busbar processing machine is needed when we process high hardness or some structural objects, so the surface quality of busbar processing machine should also be maintained. How to maintain it? Look at the following five points. 1. Surface protection should be carried out during processing to avoid damage to the surface; assemblers should wear gloves when installing to prevent the surface from leaving handprints and stains. 2. Copper busbars should be made of good materials with few surface defects and uniform color. 3. Copper busbar needs to be straightened. The bending degree of broadside of copper busbar is not more than 2 mm per metre and that of narrow busbar is not more than 3 mm per metre. 4. After bending the copper bars, no obvious cracks can be found at the corner. 5. It is strictly forbidden to fill the same size copper busbar in the round hole position for repairing under the condition of punching the wrong hole in the copper busbars.

Busbar Machining Machine  with three processing units: shearing, punching,  bending . How can we solve the problem that the bending angle of Busbar Machining Machine is not allowed? Now check below: 1: Let's first look at the inaccurate bending angle of CNC bus bar machine. Please pay attention to whether the light shed ruler has degrees, if not, then it can be judged that the light shed is broken, if there are degrees, then all degrees will be zero. 2: Solution to Incorrect Angle of  Bending Machine for Non-NC Busbar Machining Machine (1) Check whether the counter screw is loose. (2) Check whether the bending limit switch is loose. (3) Check whether the bent upper and lower crossbeams are loose. Having seen all this, I think you have some idea about how to solve the problem of bending angle of busbar processing machine .